Kriega® - US-10 Drybag 100% waterproof drybag accessory/tailpack.
The Pack
100% waterproof tailpack which also fits to Hydro 3, R15, R20, R25, R30 and R35, increasing capacity by 10 litres. The US-10 tailpack is designed to fit most race-rep style seat pads (attachment straps included).The pack is easily attached / removed by 4 x quick-release buckles. No extra bungees or covers are needed.
Mesh Pocket
The base of the US-10 tailpack has an anti-slip coated-mesh pocket for storage of D-locks / chains etc.
Fitting
The standard fit is designed for a sportsbike seat-pad. Remove the 2 x fitting straps from the US-10. Remove the bike's rear seat-pad. Lay the straps into the void of the rear seat. Replace the seat-pad and ensure it is correctly locked down (Thread the top roll-over buckle through the pillion grab-strap if present). Finally, connect all four x quick-release buckles and tighten pack down on to the seat. NB - it is important to use the 2 x strap-tidy components on each compression strap. These components ensure that there is no web-creep once the buckle has been tightened.
The US-10 can fit a traditional style one-piece seat. We recommend the use of the optional connector-straps (see link below). This option allows the loose strap-ends to connected together over the top of the seat, when not using the tailpack. The US-10 can also be used more effectively on racks by the use of the 4 x loop straps option.
This strap spec. allows the web to be 'tied' to the rack, rather than just run under it.
Tech Spec
Size: 330(H) x 220(W) x 125(D) mm - 10-litre capacity - 100% wateproof (main body) - Side access zip pocket (water-resistant) - Coated-mesh pocket - 1000D Dupont Cordura - RHINOTEK: abrasion resistant fabric - HYPALON: abrasion resistant re-enforcement - DRYPACK: taped-seam liner - 420D ripstop nylon - lightweight yet extremely strong - Acetal ITW ladderloc buckles - YKK water-resistant zip - 10-year guarantee.
|
